全文获取类型
收费全文 | 1212篇 |
免费 | 74篇 |
国内免费 | 436篇 |
专业分类
安全科学 | 60篇 |
废物处理 | 86篇 |
环保管理 | 103篇 |
综合类 | 633篇 |
基础理论 | 223篇 |
污染及防治 | 460篇 |
评价与监测 | 72篇 |
社会与环境 | 47篇 |
灾害及防治 | 38篇 |
出版年
2023年 | 11篇 |
2022年 | 53篇 |
2021年 | 41篇 |
2020年 | 34篇 |
2019年 | 50篇 |
2018年 | 41篇 |
2017年 | 54篇 |
2016年 | 54篇 |
2015年 | 88篇 |
2014年 | 103篇 |
2013年 | 130篇 |
2012年 | 107篇 |
2011年 | 101篇 |
2010年 | 87篇 |
2009年 | 73篇 |
2008年 | 109篇 |
2007年 | 82篇 |
2006年 | 64篇 |
2005年 | 55篇 |
2004年 | 50篇 |
2003年 | 46篇 |
2002年 | 41篇 |
2001年 | 30篇 |
2000年 | 26篇 |
1999年 | 29篇 |
1998年 | 26篇 |
1997年 | 23篇 |
1996年 | 23篇 |
1995年 | 16篇 |
1994年 | 14篇 |
1993年 | 16篇 |
1992年 | 12篇 |
1991年 | 9篇 |
1990年 | 4篇 |
1989年 | 2篇 |
1988年 | 5篇 |
1987年 | 1篇 |
1986年 | 1篇 |
1985年 | 3篇 |
1983年 | 3篇 |
1982年 | 1篇 |
1981年 | 2篇 |
1977年 | 1篇 |
1956年 | 1篇 |
排序方式: 共有1722条查询结果,搜索用时 781 毫秒
991.
992.
993.
药渣残留泰乐菌素的酶促降解特性 总被引:1,自引:0,他引:1
发酵法生产泰乐菌素过程中产生的药渣,因残留泰乐菌素的存在,会对环境造成不利影响。采用富集驯化方法,从堆放泰乐菌素药渣附近土壤中筛选到1株高效降解泰乐菌素的菌株,经16S rDNA鉴定为无丙二酸柠檬酸杆菌(Citrobacter amalonaticus)。该菌产生的降解泰乐菌素的主要酶是胞内组成酶。单因素实验结果显示,该酶降解泰乐菌素适宜的条件为温度35℃、pH 5.5、加酶量12%和初始底物浓度低于20 mg/L。多因素正交实验结果显示,温度对泰乐菌素的降解率影响较大。 相似文献
994.
995.
Wenjie Ren Ying Teng Qixing Zhou Albrecht Paschke Gerrit Schüürmann 《Environmental science and pollution research international》2014,21(19):11587-11597
Sorption interaction of chlorimuron-ethyl with montmorillonite clays was investigated under varied types of exchangeable cation, pH, and ionic strength conditions. Chlorimuron-ethyl sorption on bentonites exhibited pronounced cation dependency, and the sorption ability increased as the sequence Ca2+- < Na+- < Al3+- < Fe3+-bentonite, due to different sorption mechanisms, whereas the cation dependency was influenced by the clay type and much weaker for montmorillonites. The decrease of pH at the range of 4.0–6.0 prominently increased sorption of chlorimuron-ethyl on all cation-exchanged montmorillonite clays, and nearly a neglected sorption (about 2 %) can be observed at pH over 7.0. In the presence of CaCl2, sorption of chlorimuron-ethyl on Fe3+-bentonite was promoted because of complexion of Ca2+ and the surface of Fe3+-bentonite. However, as the concentration of CaCl2 increased, chlorimuron-ethyl sorption on Ca2+- and Fe3+-exchanged bentonite decreased, suggesting that Ca bridging was not the prevailing mechanism for sorption of chlorimuron-ethyl on these clays. Furthermore, chlorimuron-ethyl sorption was relatively sensitive to pH, and the change of pH may obscure effect of other factors on the sorption, so it was quite necessary to control pH at a constant value when the effect of other factor was being studied. 相似文献
996.
为了克服光合细菌光培养时的光衰减及高能耗等问题,考查了将微生物燃料电池(MFC)作为培养装置黑暗培养光合细菌的可行性。结果表明,MFC有利于菌株W1的优势生长,接种3 d后MFC内光合细菌浓度即可达到715 mg/L,而空白系统中不到308 mg/L。荧光原位杂交分析表明,MFC体系中的杂菌含量小于4%,远低于空白的33%。利用MFC进行光合细菌培养时,最大输出电压和最大输出功率可分别达到487 mV和56 mW/m2。MFC促进光合细菌生长的原因可能在于对体系兼氧环境的维持,在MFC体系中氧化还原电位始终处于200~-300 mV之间,有利于兼氧光合细菌的优势生长。 相似文献
997.
国内成功运营的餐厨垃圾处理厂臭气排放特征研究 总被引:1,自引:0,他引:1
选择目前国内成功运营的餐厨垃圾资源化处理厂为采样点,采用气相色谱.质谱联用(GC/MS)技术对该厂的主要工段,如卸料室、破碎室、湿热反应器出气口、好氧发酵仓、厌氧发酵区以及厂界的臭气进行了定性和定量的分析。结果表明,6个采样点共检测出包括芳香烃、硫化物、卤代物、烯烃、烷烃、醇、醛、酮和酯在内的9类66种物质,各采样点臭气总浓度分别为:11.738、18.390、30.917、25.097、4.737和2.635mg/m3。其中湿热反应器出气口处恶臭气体浓度最高,其芳香烃、硫化物、卤代物、烯烃、烷烃、酮及酯类物质均高于其他检测点,需对该工段进行重点监测和控制。恶臭排放特征分析表明,各点的H2S浓度均超过嗅觉阈值,除厂界外甲硫醇和二甲二硫检测值均超过嗅觉阈值。 相似文献
998.
油田压裂废液处理及回注实验 总被引:1,自引:1,他引:0
油田压裂废液具有高COD、高悬浮物等特点,处理达标难度大。以悬浮固体含量、悬浮固体颗粒粒径中值和含油量为指标,实验研究了混凝、微滤膜过滤技术参数,最佳条件为:絮凝剂投加量800~1 000mg/L,助凝剂投加量9~10mg/L,快速搅拌G值250~300s--1,慢速搅拌G值约50s--1,经50、10μm两级微滤膜过滤后悬浮固体含量、粒径中值、含油量满足SY/T 5329-2012《碎屑岩油藏注水水质指标及分析方法》标准要求。该方法工艺简单,成本低,在一定程度上解决了压裂废液难处理的问题。 相似文献
999.
1000.
为解决稠油废水的达标排放问题,构建了半饱和褐煤活性焦(HSLAC)预吸附—生物降解—褐煤活性焦吸附组合工艺处理稠油废水的中试装置(5 m3/h)。稠油废水经已吸附生化出水的HSLAC吸附预处理后,生物降解出水COD均值大幅降至82.49 mg/L,总出水COD均值为39.22 mg/L,实现了出水达标(COD≤50 mg/L)。三维荧光光谱分析表明,经HSLAC吸附预处理后,生化出水中溶解性有机碳浓度较未经吸附预处理时大幅降低,石油类和腐殖质是生化难降解的有机物。HSLAC预吸附可大幅降低处理成本。 相似文献